below - Bloomingdale Communications

Each remote control must be programmed with a 4-digit code corresponding to the brand of television in use. This was done for you at the time of installation, but must be done again whenever TVs are replaced. Follow the steps below to program each remote control for each television: Program the Remote Control - Search Method 1. Turn on your TV. 2. On the remote control, press the [TV] button once; it will blink once. Then press and hold the [SETUP] until the TV key blinks twice. 3. Enter 9 9 1. The [TV] button will blink twice. 4. Aim the remote control at the TV and press the [PWR] button once. 5. Press and release the [CH+] button continuously, then stop when the TV turns off. 6. NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first.

Each remote control must be programmed with a 4-digit code corresponding to the brand of television in use. This was done for you at the time of installation, but must be done

Loading..

Information

Related search queries