Transcription of BELT I.D. CHART - Gates Corporation
{{id}} {{{paragraph}}}
Example: bachelor of science
BELT I.D. CHART - Gates Corporation
Note: PowerGrip GT belts must be used with PowerGrip GT sprockets for new : 8mm and 14mm pitch PowerGrip GT belts can be used to replace non- Gates curvilinear belts in most instances. Reference for specific interchange V-BELTSSPCPA ramid tensile cords provide superior service on high impact, shock-loaded 5/16 21/32 13/32 7/8 17/32 7/8 5/8 1 16mm22mm13mm18mm35/64 SUPER HC & SUPER HC XP V-BELTSC ombine cross section designation with Outside Circumference ( ) to the nearest whole number, plus a zero to determine belt Part Number. Example: 5/8 top width 5VX belt with 80 equals 5VX800 V- belt . X designates molded notch 21/64 5/8 35/64 1 7/8 35/64 3/8 5/8 1 53/64 21/64 HI-POWER II V-BELTSC ombine cross section plus Inside Circumference ( ) to determine belt Part Number. To calculate , subtract the following values from the :Cross Section A B C D ESubtract from 2 3 (Above 210 , ) 4 (Above 210 , ) 5 (Above 210 , ) 7 (Above 210 , )Dubl-V belts are available in AA, BB, CC and DD cross 1-1/2 1-1/4 3/4 7/8 17/32 21/32 13/32 1/2 5/16 TRI-POWER V-BELTSTri-Power construction is identified by its distinctive molded notch 5/16 17/32 21/32 7/8 13/32 METRIC POWER V-BELTS17 XMolded notch construction is available in lengths up to 3,000mm BELTS
0”)Dubl-V belts are available in AA, BB, CC and DD cross sections. A B C D E29/32”1-1/2”1-1/4”3/4”7/8”17/32”21/32”13/32”1/2”5/16”TRI-POWER™V ...
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: