Transcription of Bottom Mount Refrigerator
{{id}} {{{paragraph}}}
Example: air traffic controller
Bottom Mount Refrigerator
PRODUCT MODEL NUMBERSPRODUCT DIMENSIONSLOCATION REQUIREMENTSE lectrical:A 115-volt, 60-Hz, AC-only, 15- or20-amp fused, grounded electrical supply isrequired. It is recommended that a separatecir cuit ser ving only your Refrigerator beprovided. Use an outlet that cannot be turnedoff by a switch. Do not use an :Before performing any type ofinstallation, cleaning, or removing a lightbulb, turn the control (Thermostat, Refrigerator or Freezer Control depending onthe model) to OFF and then disconnect therefrigerator from the electrical source. Whenyou are finished, reconnect the Refrigerator tothe electrical source and reset the control(Thermostat, Refrigerator or Freezer Controldepending on the model) to the desiredsetting. See Using the Controls. Water:A cold water supply with waterpressure between 35 and 120 psi (241 and827 kPa) is required to operate the ice makerand water dispenser. If you have questionsabout your water pressure, call a licensed,qualified :The pressure of the watercoming out of a reverse osmosis systemgoing to the water inlet valve of therefrigerator needs to be between 35 and120psi (241 and 827 kPa).
Water: A cold water supply with water pressure between 35 and 120 psi (241 and 827 kPa) is required to operate the ice maker and water dispenser. If you have questions about your water pressure,call a licensed, qualifiedplumber. IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: