Transcription of BS 729:1971 Hot-Dip Galvanized Coatings on Iron & …
{{id}} {{{paragraph}}}
MIG-MARUICHI - Hot-Dip Galvanizing Service Hot-Dip Galvanizing Service BS 729: 1971 Hot-Dip Galvanized Coatings on iron & steel Articles Table 1. coating Weight* Category Minimum average coating weight for any individual test area (in g/m ) 5mm thick and over 610 Below 5mm but not less than 2 mm 460 steel articles which are not centrifugal Below 2mm but not less than 1 mm 335 Grey and malleable iron castings 610 Threaded work and other articles which are centrifuged 305 *The coating weight per unit area of the surface is given in terms of g/m of surface. If the coating thickness is required, the following conversion factor should be used, which assumes the density of the coating to be 7 g/cm . 1 g/m2 = m (305 g/m2 = 1 oz/ft2 = 43 m = in.)
MIG-MARUICHI - Hot-Dip Galvanizing Service Hot-Dip Galvanizing Service BS 729:1971 Hot-Dip Galvanized Coatings on Iron & Steel Articles Table 1.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
IMPORTANT Liability Disclaimer, Galvanized, HOT DIP GALVANIZED COATING PROCEDURE, Coated Galvanized, Chain Link Fence, Chain Link Fence Fabric, GalvInfoNote Protecting Galvanized Steel Sheet, Protecting Galvanized Steel Sheet Products, STEELFLEX Galvanized Steel NICROFLEX Stainless, STEELFLEX Galvanized Steel NICROFLEX Stainless Steel, RoHS Compliant, Non-Chrome Passivation of, RoHS Compliant, Non-Chrome Passivation, 21500