Transcription of BS 729:1971 Hot-Dip Galvanized Coatings on Iron & Steel ...
{{id}} {{{paragraph}}}
MIG-MARUICHI - Hot-Dip Galvanizing Service Hot-Dip Galvanizing Service BS 729: 1971 Hot-Dip Galvanized Coatings on iron & Steel Articles Table 1. coating Weight* Category Minimum average coating weight for any individual test area (in g/m ) 5mm thick and over 610 Below 5mm but not less than 2 mm 460 Steel articles which are not centrifugal Below 2mm but not less than 1 mm 335 Grey and malleable iron castings 610 Threaded work and other articles which are centrifuged 305 *The coating weight per unit area of the surface is given in terms of g/m of surface. If the coating thickness is required, the following conversion factor should be used, which assumes the density of the coating to be 7 g/cm.
MIG-MARUICHI - Hot-Dip Galvanizing Service ASTM A 153-67 Zinc Coating (Hot-Dip) on Iron & Steel Hardware Class of Material Minimum weight of Zinc
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}