Transcription of C2301/C2302 Installation Instructions 2001-2010 …
{{id}} {{{paragraph}}}
Example: air traffic controller
C2301/C2302 Installation Instructions 2001-2010 …
Read and understand all Instructions and warnings prior to Installation of product and operation of Offroad Products recommends this system be installed by a professional technician. In addition to these Instructions , profes-sional knowledge of disassembly/ reassembly procedures and post Installation checks must be known. Minimum tool requirements include the following: Assorted metric and standard wrenches, hammer, hydraulic floor jack and a set of jack stands. See the "Special Tools Required" section for additional tools needed to complete this Installation properly and safely. Product Safety WarningCertain Zone Suspension Products are intended to improve off-road performance. Modifying your vehicle for off-road use may result in the vehicle handling differently than a factory equipped vehicle.
C2301/C2302 Installation - pg. 3 6. Remove the torsion bar adjusting bolts, do not mix the right and left bolt. Fig 1 Figure 2 7. Use the torsion bar removal tool to remove the threaded adjuster assembly.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: