Transcription of CAD Standards User’s Guide - USDA
{{id}} {{{paragraph}}}
Example: dental hygienist
CAD Standards User’s Guide - USDA
CAD Standards User's Guide May 2005. VERSION Introduction The following AutoCAD User's Guide was compiled by the Regional Office - Center for Design and Interpretation (CDI) and represents a collaborated effort by the AutoCAD. Standards committee members (see Contributor/Reference page near back of document). These Standards are intended for Forest Service employees throughout the region, as well as architectural and engineering (A&E) contractors for the use in the preparation of Computer Aided Design (CAD) construction and design drawings for the Forest Service. The purpose of this document is to establish Standards , which will result in the preparation of consistent and compatible AutoCAD files. It is intended to Guide users in the overall CAD system, operations, and to establish Standards and procedures that will avoid duplication of effort and maintain uniformity of work.
Approval Blocks – The project approval block is located on the cover sheet of all design and construction drawing sets. Refer back to Figure 2-3 to see the location of the approval block in relation to the cover (title) sheet. See Figure 2-6 for an example of the approval block to be used on the cover sheet of all construction-drawing sets.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: