Transcription of Calibrate the Ribbon and Media Sensors
{{id}} {{{paragraph}}}
Example: biology
Calibrate the Ribbon and Media Sensors
Printer Configuration and AdjustmentCalibrate the Ribbon and Media Sensors98P1048261-004 8/22/12 Calibrate the Ribbon and Media SensorsUse the procedure in this section to Calibrate the printer, which adjusts the sensitivity of the Media and Ribbon Sensors . For a summary of the options for initiating calibration , see Media and Ribbon Sensor calibration on page 87. To perform sensor calibration , complete these the printer in the Ready state, initiate Media and Ribbon calibration in one of these ways: Press and hold 3$86( + &$1&(/ for 2 seconds. 8 SGDWHG ZFN Send the SGD command to the printer. See the Zebra Programming Guide for more information about this command. ZT230 printer only: =7 IROORZ SURFHVV LQWHUDFWLQJ ZLWK WKH 3 DXVH EXWWRQ to the following menu item on the control panel display.))
Calibration on page 87. To perform sensor calibration, complete these steps: 1. With the printer in the Ready state, initiate media and ribbon calibration in one of these ways: • Press and hold 3$86( + &$1&(/ for 2 seconds. 8SGDWHG ZFN ezpl.manual_calibration e h t d n e•S SGD command to th e printer. See the
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: