Transcription of Call Letters PSTC-16 Revised Loop Tack
{{id}} {{{paragraph}}}
Example: air traffic controller
Call Letters PSTC-16 Revised Loop Tack
53 Loop Tack1. This test method is intended to determine the tack properties of a pressure sensitive adhesive. This test method is applicable to those adhesives that form a bond of measurable strength rapidly upon contact with another surface. tack force may be measured as the force required to separate the adhesive from the adherend at the interface shortly after they have been brought into contact under a load equal only to the weight of the pressure sensitive article ( , tape, label, sticker, etc.) on a one square inch contact The following test methods are included: Test Method A (using tensile tester) Test Method B (using loop tack tester) The values stated in Newtons per 10 mm of width are to be regarded as the standard.
53 Loop Tack 1. SCOPE 1.1 This test method is intended to determine the tack properties of a pressure sensitive adhesive. This test method is applicable to those adhesives that form a bond of measurable strength rapidly upon contact with another surface.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: