Transcription of Chapter 15 Surface Modeling - SolidWorks Thai
{{id}} {{{paragraph}}}
Example: bachelor of science
Chapter 15 Surface Modeling - SolidWorks Thai
CADCIM Technologies, USA. For engineering services, contact Chapter 15. Surface Modeling Learning Objectives After completing this Chapter you will be able to: Create Extruded Surface . Create Revolved Surface . Create Swept Surface . Create Lofted Surface . Create Planar Surface . Create Fill Surface . Create Radiated Surface . Offset the surfaces. Trim the surfaces. Untrim the surfaces. Extend the surfaces. Knit the surfaces. Fillet the surfaces. Create a Mid- Surface . Delete Holes. Replace the faces. Delete the faces.
In SolidWorks, you can also create a surface by lofting two or more sections. To create a lofted surface, choose the Lofted Surface button from the Surfaces toolbar. The Surface-Loft PropertyManager is invoked as shown in Figure 15-20 and you are prompted to select at least 2 profiles. Select the profiles to be lofted. All the options of creating
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: