Transcription of Chapter 9 Lab A: Configuring ASA Basic Settings and ...
{{id}} {{{paragraph}}}
Example: tourism industry
Chapter 9 Lab A: Configuring ASA Basic Settings and ...
2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 26 CCNA Security Chapter 9 Lab A: Configuring ASA Basic Settings and Firewall Using CLI This lab has been updated for use on NETLAB+ Topology Note: ISR G2 devices use GigabitEthernet interfaces instead of FastEthernet interfaces. CCNA Security Chapter 9 Lab 2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 26 IP Addressing Table Device Interface IP Address Subnet Mask Default Gateway Switch Port R1 G0/0 N/A ASA G1/1 S0/0/0 (DCE) N/A N/A R2 S0/0/0 N/A N/A S0/0/1 (DCE) N/A N/A R3 G0/1 N/A S3 F0/5 S0/0/1 N/A N/A ASA G1/2 NA S2 F0/24 ASA G1/1 NA R1 G0/0 ASA G1/3 NA S1 F0/24 PC-A NIC S1 F0/6 PC-B NIC S2 F0/18 PC-C NIC S3 F0/18 Objectives Part 1: Basic Router/Switch/PC Configuration Configure hostnames and interface IP addresses for routers, switches, and PCs.
Inside users can access the DMZ and outside resources. The focus of this lab is the configuration of the ASA as a basic firewall. Other devices will receive minimal configuration to support the ASA portion of this lab. This lab uses the ASA CLI, which is similar to the IOS CLI, to configure basic device and security settings.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: