Transcription of Chrysler Drive Cycle Information - OBD2
{{id}} {{{paragraph}}}
Chrysler Drive Cycle Information Note: 1996 Chrysler vehicles do not maintain readiness after engine shutdown. The vehicles can be re-programmed to fix this problem, and may already have had a re- programming that addressed this issue. All Monitor Drive Trace Pre-Conditioning Requirements: - MIL must be off - Cold start (Note: cold start temperature is undefined). Driving Procedure 1) Warm engine up for five minutes (must reach closed loop). 2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes. 4) Drive (with steady throttle) at a speed above 20 mph for 2 minutes. 5) Turn key off, leave off for ten minutes (to run O2 sensor heater monitor).
Chrysler Drive Cycle Information Copyright 1999-2005, EASE Diagnostics. All rights reserved. Information is subject to change without notice.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Modified Brostrom Procedure Rehabilitation, Procedure, METHOD OF PROCEDURE (MOP) DEVELOPMENT, ORACLE, METHOD OF PROCEDURE (MOP) DEVELOPMENT SERVICE, HIRING POLICY AND PROCEDURE POLICY, HIRING POLICY AND PROCEDURE. POLICY, LOCKOUT/TAGOUT PROCEDURE INSPECTION FORM, CIVIL PROCEDURE, Supreme Court of Ohio, TAPPING PROCEDURE The Basic Recipe, 2017-37