Transcription of Chrysler Drive Cycle Information - OBD2
{{id}} {{{paragraph}}}
Example: biology
Chrysler Drive Cycle Information - OBD2
Chrysler Drive Cycle Information Note: 1996 Chrysler vehicles do not maintain readiness after engine shutdown. The vehicles can be re-programmed to fix this problem, and may already have had a re- programming that addressed this issue. All Monitor Drive Trace Pre-Conditioning Requirements: - MIL must be off - Cold start (Note: cold start temperature is undefined). Driving Procedure 1) Warm engine up for five minutes (must reach closed loop). 2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes. 4) Drive (with steady throttle) at a speed above 20 mph for 2 minutes. 5) Turn key off, leave off for ten minutes (to run O2 sensor heater monitor). Note: Due to the limited preconditions provided with this Drive trace, NCVECS.
2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes. 4) Drive (with steady throttle) at a speed above 20 mph for 2 minutes.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Board Diagnostic (OBD) Readiness and Drive Cycle, Board Diagnostic (OBD) Readiness and Drive Cycle Information, Ford, Drive cycle, EVAP, Information, Dynamometer Testing of USPS EV Conversions, Drive cycle information, Pennsylvania Emissions Inspection Publication, Drive, Super Duty Pickups F-250, Super Duty® Pickups F-250, Ford drive, Cycle, OBD Readiness, Diesel exhaust FluiD, Powertrain DTC Summaries – OBD II, OBD I/M Check Fact Sheet, FACT SHEET