Transcription of Command Line Interface (CLI) Commands - Cisco
{{id}} {{{paragraph}}}
Example: marketing
Command Line Interface (CLI) Commands - Cisco
A-1 Cisco TelePresence Multipoint Switch Release Administrator s GuideOL-12586-03 APPENDIXAC ommand line Interface (CLI) CommandsInitial Release: February 25, 2009, OL-12586-03 NoteFor the most complete version of the CTMS CLI Commands , see the online version of the CTMS Release Administration Guide at the following URL: of Contents Introduction section on page A-1 Starting a CLI Session section on page A-1 CLI Command Basics section on page A-2 Ending a CLI Session section on page A-2 CTMS CLI Commands section on page A-2 IntroductionThis chapter explains how to use Cisco TelePresence Multipoint Switch (CTMS) Command line Interface (CLI) a CLI SessionYou can access the CTMS CLI through the physical console or remotely. If accessing the CTMS CLI remote, use Secure Shell (SSH) from a personal computer or workstation to connect securely to you begin, be sure that you have the following information: CTMS IP address Admin ID and passwordYou will need this information to log into TelePresence Multipoint Switch Release Administrator s GuideOL-12586-03 Appendix A Command line Interface ()
† utils ntp config, page A-198 † utils ntp restart, page A-199 † utils ntp start, page A-200 † utils ntp status, page A-201 † utils remote_account create, page A-202 † utils remote_account disable, page A-203 † utils remote_account enable, page A-204 † utils remote_account status, page A-205 † utils system restart, page A-206
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: