Command Line Interface (CLI) Commands - Cisco

A-1 Cisco TelePresence Multipoint Switch Release Administrator s GuideOL-12586-03 APPENDIXAC ommand line Interface (CLI) CommandsInitial Release: February 25, 2009, OL-12586-03 NoteFor the most complete version of the CTMS CLI Commands , see the online version of the CTMS Release Administration Guide at the following URL: of Contents Introduction section on page A-1 Starting a CLI Session section on page A-1 CLI Command Basics section on page A-2 Ending a CLI Session section on page A-2 CTMS CLI Commands section on page A-2 IntroductionThis chapter explains how to use Cisco TelePresence Multipoint Switch (CTMS) Command line Interface (CLI) a CLI SessionYou can access the CTMS CLI through the physical console or remotely. If accessing the CTMS CLI remote, use Secure Shell (SSH) from a personal computer or workstation to connect securely to you begin, be sure that you have the following information: CTMS IP address admin ID and passwordYou will need this information to log into TelePresence Multipoint Switch Release Administrator s GuideOL-12586-03 Appendix A Command line Interface (CLI) Commands Ending a CLI Sessio

† adminname is the Admin ID † IP Address is the IP address of CTMS Step 2 When the system prompts you, enter the password. Step 3 The CLI prompt (admin) displays. You can now enter any CLI command. Note The prompt will always be “admin.” CLI Command Basics † Enter the beginning of a command and press Tab to have the system complete ...

Loading..

Tags:

  Cisco, Line, Interface, Command, Password, Admin, Command line interface

Information

Related search queries