Configuring Call Transfer and Forwarding

755 Cisco Unified Communications Manager Express System Administrator GuideOL-10663-03 Configuring call Transfer and ForwardingLast Updated: March 15, 2013 This chapter describes call Transfer and Forwarding features in Cisco Unified Communications Manager Express (Cisco Unified CME) to enable interworking with various network requirements. Finding Feature Information in This ModuleYour Cisco Unified CME version may not support all of the features documented in this module. For a list of the versions in which each feature is supported, see the Feature Information for call Transfer and Forwarding section on page Information About call Transfer and Forwarding , page 755 How to Configure call Transfer and Forwarding , page 778 Configuration Examples for call Transfer and Forwarding , page 822 Where to Go Next, page 832 Additional References, page 832 Feature Information for call Transfer and Forwarding , page 834 Information About call Transfer and For

Mar 15, 2013 · For example, the following commands set up a single ephone-dn (ephone-dn 5) with four dial peers: telephony-service dialplan-pattern 1 40855501.. extension-length 4 extension-pattern 50.. ephone-dn 5 number 5066 secondary 5067 In this example, selective call forwarding can be applied so that calls are forwarded when:

Loading..

Tags:

  Call, Transfer, Command, Forwarding, Configuring, Configuring call transfer and forwarding

Information

Related search queries