Transcription of Configuring DHCP Snooping - Cisco
{{id}} {{{paragraph}}}
Example: air traffic controller
Configuring DHCP Snooping - Cisco
CHAPTER37-1 Catalyst 6500 series Switch Cisco IOS Software Configuration Guide, Release DHCP Snooping This chapter describes how to configure Dynamic Host Configuration Protocol (DHCP) Snooping on Catalyst 6500 series switches . Note The DHCP Snooping feature requires PFC3 and Release (18)SXE and later releases. The PFC2 does not support DHCP Snooping . For complete syntax and usage information for the commands used in this chapter, refer to the Cisco IOS Master Command List, Release at this URL: This chapter consists of the following major sections: Understanding DHCP Snooping , page 37-1 Default Configuration for DHCP Snooping , page 37-6 DHCP Snooping Configuration Restrictions and Guidelines, page 37-7 Configuring DHCP Snooping , page 37-9 TipFor additional information about Cisco Catalyst 6500 series switches (including configuration examples and troubleshooting information), see the documents listed on this page: Participate in the Technical Documentation Ideas forum Understanding DHCP SnoopingThese sections describe the DHCP Snooping feature.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide, Release 12.2SXF OL-3999-08 37 Configuring DHCP Snooping This chapter describes how to configure Dynamic Host Configuration Protocol (DHCP) snooping on Catalyst 6500 series switches. Note • The DHCP snooping feature requires PFC3 and Re lease 12.2(18)SXE and later releases ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: