Configuring DHCP Snooping - Cisco

CHAPTER37-1 Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide, Release DHCP Snooping This chapter describes how to configure Dynamic Host Configuration Protocol (DHCP) Snooping on Catalyst 6500 series switches. Note The DHCP Snooping feature requires PFC3 and Release (18)SXE and later releases. The PFC2 does not support DHCP Snooping . For complete syntax and usage information for the commands used in this chapter, refer to the Cisco IOS Master Command List, Release at this URL: This chapter consists of the following major sections: Understanding DHCP Snooping , page 37-1 Default Configuration for DHCP Snooping , page 37-6 DHCP Snooping Configuration Restrictions and Guidelines, page 37-7 Configuring DHCP Snooping , page 37-9 TipFor additional information about Cisco Catalyst 6500

Catalyst 6500 series switches. Note • The DHCP snooping feature requires PFC3 and Re lease 12.2(18)SXE and later releases. The PFC2 does not support DHCP snooping. † For complete syntax and usage information for the commands used in this chapter, refer to the Cisco IOS Master Command List, Release 12.2SX at this URL:

Loading..

Tags:

  Cisco, 6500, Configuring, Catalysts, Chdp, Catalyst 6500, Configuring dhcp snooping, Snooping

Information