Configuring HSRP - Cisco

CHAPTER 1-1 Catalyst 3560 Switch Software Configuration GuideOL-8553-071 Configuring HSRP This chapter describes how to use Hot Standby Router Protocol (HSRP) on the Catalyst 3560 switch to provide routing redundancy for routing IP traffic not dependent on the availability of any single router. HSRP for IPv4 is supported on switches running the IP base or IP services image. To use HSRP for IPv6, see Chapter 38, Configuring IPv6 Unicast Routing. You can also use a version of HSRP in Layer 2 mode to configure a redundant command switch to take over cluster management if the cluster command switch fails.

1-6 Catalyst 3560 Switch Software Configuration Guide OL-8553-07 Chapter 1 Configuring HSRP Configuring HSRP – EtherChannel port channel in Layer 3 mode: a port-channel logical interface created by using the interface port-channel port-channel-number global configuration command and binding the Ethernet interface into the channel group.

Loading..

Tags:

  Cisco, Configuring, Catalysts, 3650, Sphr, Catalyst 3650, Configuring hsrp, Configuring hsrp configuring hsrp

Information