Transcription of Configuring HSRP - Cisco
{{id}} {{{paragraph}}}
Example: dental hygienist
Configuring HSRP - Cisco
CHAPTER 1-1 Catalyst 3560 Switch software Configuration GuideOL-8553-071 Configuring HSRP This chapter describes how to use Hot Standby Router Protocol (HSRP) on the Catalyst 3560 switch to provide routing redundancy for routing IP traffic not dependent on the availability of any single router. HSRP for IPv4 is supported on switches running the IP base or IP services image. To use HSRP for IPv6, see Chapter 38, Configuring IPv6 Unicast Routing. You can also use a version of HSRP in Layer 2 mode to configure a redundant command switch to take over cluster management if the cluster command switch fails. For more information about clustering, see Chapter 5, Clustering Switches and see the Getting Started with Cisco Network Assistant, available on complete syntax and usage information for the commands used in this chapter, see these documents: Switch command reference for this release Cisco IOS IP Command Reference, Volume 1 of 3: Addressing and Services, Release at Hot Standby Router Protocol Version 2 feature module at chapter consists of these sections: Understanding HSRP, page 1-1 Configuring HSRP, page 1-4 Displaying HSRP Configurations, page 1-13 Understa
1-2 Catalyst 3560 Switch Software Configuration Guide OL-8553-07 Chapter 1 Configuring HSRP Understanding HSRP Note Routers in an HSRP group can be any router interface that supports HSRP, including Catalyst 3560 routed ports and switch virtual interfaces (SVIs).
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: