Transcription of Configuring PPPoE - Cisco
{{id}} {{{paragraph}}}
CHAPTER 17-1 Cisco 910 Industrial Router Software Configuration Guide, Release PPPoE This section describes how to configure the Point-to-Point over Ethernet ( PPPoE ) client on the Cisco 910 Industrial Routers (hereafter referred to as the router). It includes the following topics: PPPoE Client Overview, page 17-1 Configuring PPPoE , page 17-1 Monitoring the PPPoE Client, page 17-3 PPPoE Client OverviewThe Point-to-Point over Ethernet ( PPPoE ) is a network protocol for encapsulating PPP frames inside Ethernet frame. PPPoE combines Ethernet and PPP, to provide an authenticated method of assigning IP addresses to client systems. The Cisco 910 Industrial Router can be configured as a PPPoE client, so that a tunnel can be established for the router to access the WAN. At system initialization, the PPPoE client establishes a session with the access concentrator by exchanging a series of packets. Once the session is established, a PPP link is set up, which includes authentication using Password Authentication protocol (PAP).
† Configuring PPPoE, page 17-1 † Monitoring the PPPoE Client, page 17-3 PPPoE Client Overview The Point-to-Point over Ethernet (PPPoE) is a network protocol for encapsulating PPP frames inside Ethernet frame. PPPoE combines Ethern et and PPP, to provide an authen ticated method of assigning IP addresses to client systems.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}