CONNECTOR - RS Components
2.5mm pitch/Disconnectable Crimp style connectors Emboss Tape Radial Tape ... The shrouded headers are interchangeable with those of the NR and NRD insulation displacement connectors, and JQ board-to-board connectors. Through-hole type shrouded header. 4 XH CONNECTOR 6 5.5 2.5 B 3.75 A 0.64
Tags:
Pitch, Displacement, Insulation, Disconnectable, Insulation displacement
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
LOCTITE 243™
docs.rs-online.comTDS LOCTITE® 243™, August-2016 For Cleanup 1. Cured product can be removed with a combination of soaking in a LOCTITE® solvent and mechanical abrasion such as a wire brush Loctite Material SpecificationLMS LMS dated June-29, 2009.
Shelf Life for Loctite Products - RS Components
docs.rs-online.comThe shelf life period for Loctite® products is one year from date of shipment from Henkel facilities or as indicated by package labeling. For optimal storage, maintain product at a temperature between 8°C (46°F) to 21°C (70°F). Storage below 8°C (46°F) or greater than 28°C (82°F) can adversely affect product properties.
AC Industrial Electric Motors Data Sheet
docs.rs-online.comThe power factor usually being referred to as cos Ø. The power factor is usually between 0.7 and 0.9, however this may vary depending on the motor size and rating. If there are many motors in an installation they will consume a lot of reactive power and will therefore have a lower power factor. Power supply authorities sometimes require the
SIM868 Hardware Design V1.00-150516 - RS Components
docs.rs-online.comSIM868 is a quad-band GSM/GPRS module that works on frequencies GSM 850MHz, EGSM 900MHz, DCS 1800MHz and PCS 1900MHz. SIM868 features GPRS multi-slot class 12/class 10 (optional) and supports
APPLICATION MKS-L MKS-SC
docs.rs-online.comNote: (1) These tools are for prototype tooling or repair. (2) YC tool has two crimping sections (A and B). YRS tool has also two crimping sections by inverting upper dies. Be sure to check applicable wires before use. Since the dies are fixed, the crimping height cannot be adjusted. Therefore, some of the
APC Smart-UPS X-Series 2000/2200/3000 VA Operation Manual
docs.rs-online.comSmart-UPS X 2000/2200/3000 VA 1 Overview About the UPS The APC® by Schneider Electric Smart-UPS® X is a high performance uninterruptible power supply (UPS). It provides protection for electronic equipment from utility power blackouts, brownouts, sags,
Power, Smart, Supply, Uninterruptible power supply, Uninterruptible, Smart ups
Charger Instructions for Duracell High-Speed Chargers (ALL)
docs.rs-online.com5. The charger is capable of accepting 100-240 V AV 50/60 Hz and therefore, can be used overseas with a corresponding regional plug converter. 6. If battery is fully charged and then reinserted right away into the charger, the fault Red Blinking LED indicator may occur since the battery is already fully charged 7.
Programmable Logic Controllers Beginner´s Manual
docs.rs-online.comThe programmable logic controllers of the FX1S,FX1N,FX2N,FX2NC,FX3G,FX3GC,FX3GE, FX3S,FX3U and FX3UC series are only intended for the specific applications explicitly described in this manual. All parameters and settings specified in this manual must be observed. The products described have all been designed, manufactured, tested and docu-
PLATINUM RESISTANCE THERMOMETER (PRT)
docs.rs-online.comBuy this and more at rspro.com RS PRO Sensors - PRT Guide 3 COMPARISON OF SENSOR TYPES PLATINUM RESISTANCE THERMOMETER THERMOCOUPLE THERMISTOR Sensor Platinum-wire wound or flatfilm resistor Thermoelement, two dissimilar metals/alloys Ceramic (metal oxides) Accuracy (typical values) 0.1 to 1.0°C 0.5 to 5.0°C 0.1 to 1.5°C Long term …
Data sheet 6ES7131-6BH01-0BA0
docs.rs-online.comfor standard inputs — parameterizable Yes; 0.05 / 0.1 / 0.4 / 0.8 / 1.6 / 3.2 / 12.8 / 20 ms (in each case + delay of 30 to 500 µs, depending on line length)
Related documents
1.0mm pitch/Disconnectable Insulation displacement …
www.jst-mfg.com• Compact insulation displacement connector • Header designed for vacuum pick and place robotics • Twin U-slot insulation displacement section • 3-point grip construction • Through-hole type (SZ) 1 JST 9 SR/SZ CONNECTOR 1.0mm pitch/Disconnectable Insulation displacement connectors Emboss Tape Header outline 2.95 4.85 0.6±0.05 0.7 ±0 ...
Pitch, Displacement, Insulation, Disconnectable, Insulation displacement, Pitch disconnectable insulation displacement
Handling Precautions for Terminals and Connectors
www.jst-mfg.comWhen disconnectable "terminals and connectors" are connected and disconnected (hereinafter referred to ... narrow pitch connector has a high possibility to come off from contact point due to warpage, deformation, slant insertion, insufficient insertion and so on of FPC/FFC. ... applicable wires for crimping connector and insulation displacement ...
Pitch, Displacement, Insulation, Disconnectable, Insulation displacement
XH CONNECTOR XH CONNECTOR - JST
www.jst.com2.5 mm pitch/Disconnectable Crimp style connectors Emboss Tape Radial Tape 1.8 1.6 6.5 2.35 1.95 6.5 2 2.4 7.75 4.1 5.7 A B C Circuit No.1 mark 7.75 4.1 5.7 2.5 A B C Circuit No.1 mark 7.75 4.1 5.7 A B C Circuit No.1 mark XHコネクタ表1 Material and Finish Model No. Applicable Wire Q’ty/ mm2 AWG# reel Insulation O.D (mm) Phosphor bronze ...
Pitch, Connectors, Insulation, Disconnectable, Xh connector xh connector