Connector Selection Guide - RS Components
R/S Copper Copper Alloy 455-9887 70644399 769-1114 70652121 771-8773 70652312 B Copper Copper 774-7181 70652487 769-1094 70652115 771-8764 70652309 E Nickel Chromium Copper Nickel 774-7185 70652488 769-1098 70652116 771-8767 70652310 Cu Copper Copper 455-9679 70644384 - - - - A B ANSI Miniature PlugIEC Miniature Plug
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
LOCTITE 243™
docs.rs-online.comTDS LOCTITE® 243™, August-2016 For Cleanup 1. Cured product can be removed with a combination of soaking in a LOCTITE® solvent and mechanical abrasion such as a wire brush Loctite Material SpecificationLMS LMS dated June-29, 2009.
Shelf Life for Loctite Products - RS Components
docs.rs-online.comThe shelf life period for Loctite® products is one year from date of shipment from Henkel facilities or as indicated by package labeling. For optimal storage, maintain product at a temperature between 8°C (46°F) to 21°C (70°F). Storage below 8°C (46°F) or greater than 28°C (82°F) can adversely affect product properties.
AC Industrial Electric Motors Data Sheet
docs.rs-online.comThe power factor usually being referred to as cos Ø. The power factor is usually between 0.7 and 0.9, however this may vary depending on the motor size and rating. If there are many motors in an installation they will consume a lot of reactive power and will therefore have a lower power factor. Power supply authorities sometimes require the
SIM868 Hardware Design V1.00-150516 - RS Components
docs.rs-online.comSIM868 is a quad-band GSM/GPRS module that works on frequencies GSM 850MHz, EGSM 900MHz, DCS 1800MHz and PCS 1900MHz. SIM868 features GPRS multi-slot class 12/class 10 (optional) and supports
APPLICATION MKS-L MKS-SC
docs.rs-online.comNote: (1) These tools are for prototype tooling or repair. (2) YC tool has two crimping sections (A and B). YRS tool has also two crimping sections by inverting upper dies. Be sure to check applicable wires before use. Since the dies are fixed, the crimping height cannot be adjusted. Therefore, some of the
APC Smart-UPS X-Series 2000/2200/3000 VA Operation Manual
docs.rs-online.comSmart-UPS X 2000/2200/3000 VA 1 Overview About the UPS The APC® by Schneider Electric Smart-UPS® X is a high performance uninterruptible power supply (UPS). It provides protection for electronic equipment from utility power blackouts, brownouts, sags,
Power, Smart, Supply, Uninterruptible power supply, Uninterruptible, Smart ups
Charger Instructions for Duracell High-Speed Chargers (ALL)
docs.rs-online.com5. The charger is capable of accepting 100-240 V AV 50/60 Hz and therefore, can be used overseas with a corresponding regional plug converter. 6. If battery is fully charged and then reinserted right away into the charger, the fault Red Blinking LED indicator may occur since the battery is already fully charged 7.
Programmable Logic Controllers Beginner´s Manual
docs.rs-online.comThe programmable logic controllers of the FX1S,FX1N,FX2N,FX2NC,FX3G,FX3GC,FX3GE, FX3S,FX3U and FX3UC series are only intended for the specific applications explicitly described in this manual. All parameters and settings specified in this manual must be observed. The products described have all been designed, manufactured, tested and docu-
PLATINUM RESISTANCE THERMOMETER (PRT)
docs.rs-online.comBuy this and more at rspro.com RS PRO Sensors - PRT Guide 3 COMPARISON OF SENSOR TYPES PLATINUM RESISTANCE THERMOMETER THERMOCOUPLE THERMISTOR Sensor Platinum-wire wound or flatfilm resistor Thermoelement, two dissimilar metals/alloys Ceramic (metal oxides) Accuracy (typical values) 0.1 to 1.0°C 0.5 to 5.0°C 0.1 to 1.5°C Long term …
Data sheet 6ES7131-6BH01-0BA0
docs.rs-online.comfor standard inputs — parameterizable Yes; 0.05 / 0.1 / 0.4 / 0.8 / 1.6 / 3.2 / 12.8 / 20 ms (in each case + delay of 30 to 500 µs, depending on line length)
Related documents
Smog Check Inspector and/or Smog Check Repair Technician ...
www.bar.ca.govinformation by Business and Professions Code sections 30 and 9887.2, Labor Code section 432.7, Civil Code section 1798 et seq. (Information Practices Act), and California Code of Regulations section 3306. • Pursuant to Business and Professions Code section 27, the address of record is a public record and will be posted on BAR’s website.
Receive rental assistance at another property RHIIP
www.hud.govHUD-9887 that you must sign have access to the information in EIV pertaining to you. What are my responsibilities? As a tenant in a HUD assisted property, you must certify that information provided on an application for housing assistance and the form used to certify and recertify your assistance (form HUD-50059) is accurate and honest.
CHILD-RELATED 2021TAX CREDITS
www.irs.gov1-800-906-9887 to find a site near you. Use the EITC Assistant Advance Child Tax Credit Eligibility Find a Location for Free Tax Prep. Title: Publication 5585 (12-2021) Author: SE:W:CAR:SPEC:PS&A Subject: Child-Related 2021 Tax Credits Created Date:
学生アルバイトに係る労働基準法などの違反事例を紹介します
jsite.mhlw.go.jp滋賀労働局発 学生アルバイトに係る労働基準法などの違反事例を紹介します ~まずは、書面による労働条件の明示とその確認がトラブル回避の第一歩です~
Fish Stocking Report 2021 - Alberta
open.alberta.caAF3N 21.3 9,887 3/May/21 Cow Lake NE12-38-8-W5 RNTR Trout Lodge/Jumpers AF3N 21.0 6,313 4/May/21 Cow Lake NE12-38-8-W5 RNTR Trout Lodge/Kamloops AF3N 15.5 30,000 11/May/21 Cow Lake NE12-38-8-W5 RNTR Trout Lodge/Jumpers AF3N 18.4 8,100 11/May/21 Cow Lake NE12-38-8-W5 BNTR Bow River 3N 17.2 8,000 11/May/21 Crowsnest Lake
Federal Income Tax Withholding after
www.irs.govMany retired military members are surprised at the amount of federal income tax they owe when they file their first tax return after retiring from the military.
歯科診療報酬点数早見表 - shien.co.jp
www.shien.co.jp28 ※赤字は令和3年4月改定部分 ( ) 一般用 (枝番) 58052084 052 65 190 420 175 317 48 38 60 10 30 45 60 75 50 110 200 25 55 100 100 220 400