Transcription of Considerations for Hurricane Tie Selection
{{id}} {{{paragraph}}}
Example: bankruptcy
Considerations for Hurricane Tie Selection
HCatalog C-2003 Copyright 2002 SIMPSON STRONG-TIE CO., ANDHURRICANE TIESThe is symetrically designed for easy installation,with higher uplift loads to meet new code requirements. Aplacement mark allows easy installation on double top H5A has an installed cost benefit, as it only requires 6nails, to meet lower uplift H connector series provides wind/seismic ties for truss-es and rafters. MATERIAL: See table FINISH: Galvanized. H11Z made in Z-MAX. Some models avail-able in stainless steel or Z-MAX; see Corrosion-Resistance, pg : Use all specified fasteners. See General Notes. H1 can be installed with flanges facing inwards(reverse ofH1drawing number 1). When installed inside a wall, abirdsmouth cut is required. , H3, H4, H5 and H6 ties are shipped in equal quanti-ties of rights and lefts. Bend the H7 over the top of the truss. Install a minimumof four 8d nails into the truss, including two into the trussside.
H Catalog C-2003 © Copyright 2002 SIMPSON STRONG-TIE CO., INC. SEISMIC AND HURRICANE TIES The H2.5A is symetrically designed for easy installation,
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Thermowell Selection and Application, Considerations, CONSIDERATIONS IN APPLICATION AND SELECTION, Application, BASIC GASKET APPLICATION GUIDE & MATERIAL SELECTION, BASIC GASKET APPLICATION GUIDE & MATERIAL SELECTION Application, CHAPTER, Measurement Accuracy Considerations for Tapered, Selection and Application of Conformal Coatings, Considerations for Encapsulant Material Selection, Considerations for Encapsulant Material Selection for Phosphor, Electro-Optical Tracking Systems Considerations, Application Guide: LP-Gas Regulators, Selection