Transcription of CONTENTS Heating & Air Conditioning 1E78
{{id}} {{{paragraph}}}
Example: tourism industry
CONTENTS Heating & Air Conditioning 1E78
CONTENTS . 1. Thermostat 1. Installation Instructions for Removing Old 1. Heating & Air Conditioning Mounting and 2. Check Thermostat 3. 1E78 4. 4. Non-Programmable Heat Only Thermostat YOUR THERMOSTAT REPLACES. Typical System Compatibility Chart 1E78. 1 PREPARATIONS. Standard Heat Only Two Wire Gas or Oil Fired Systems (24 volt) Yes Assemble tools required as shown below. Electronic Ignition Heat Only Two Wire Systems (24 volt) Yes Electronic Ignition Heat Only Gas or Oil Fired Systems (24 volt) Yes Standard Heat/Cool Systems (24 volt) No FLAT BLADE SCREWDRIVER. Heat/Cool Systems Electric Heat (24 volt) No Heat Only Electric Heat Systems (24 volt) No HAND OR POWER. Cool Only Systems No DRILL WITH 3/16 INCH. DRILL BIT, IF NEEDED. Heat Pump Systems (No Aux. or Emergency Heat) No Hot Water Zone Heat Only (Two Wire) Systems Yes WIRE CUTTER/STRIPPER. Hot Water Zone Heat Only (Three Wire) Systems No Line Voltage Heating or Baseboard 110/240 Volt Systems No Millivolt Systems Floor or Wall Furnaces Yes Failure to follow and read all instructions carefully 12 VDC Mobile Home Application Yes before installing or operating this control could cause Multistage Systems No Systems Exceeding 30 VAC, Amp No personal injury and/or property damage.
3 NOTE To prevent static discharge problems, touch side of thermostat to release static build-up before touching any keys. If at any time during testing your system does not operate
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: