OPERATION & MAINTENANCE MANUAL for VERTICAL …

Figure 7-F Figure 7-G Figure 7-H SECTION 8 Figure 8-A Figure 8-B ... The drivers, couplings, and strainers (when used) are shipped loose to prevent damage. ... The suction bell or case directs the fluid into the first stage impeller. Bearings are located in the suction bell, discharge case, and between each impeller. ...

  Suction, Strainers

Fire Pump Inspection Checklist - PPSA

suction source. For open bodies of water, check the suction in-take for possible obstructions. Verify drought or dry conditions have not significantly reduced the water supply. For public supply booster pumps, check all valves on the suction line. Pump Room Temperature n Minimum temperature should be 40º F (4º C). For internal

  Checklist, Pumps, Fire, Inspection, Suction, Fire pump inspection checklist

Daily & Montly Checklist 04JUN2007

Note 2: Reject shipment if the measured API gravity, corrected to 60 °F, is not within ± 1.0 °API of that shown on the bill of lading. Note 3: Verify addition of FSII at the correct rate, within 1.0 to 1.5-gallons FSII per 1000-gallons of Jet A loaded.

In-Line Air Separators - TACO - HVAC

is designed for working pressures of 125 psi at 375˚F. Optional 150, 250 and 300 psi maximum pressure units, 375˚F maximum temperature units are also available. Taco air separators are manufactured from carbon steel listed in ASME Section II. Consult the factory for higher working pressures, larger sizes or non-standard materials of construction.

  Coat, Hvac, Separator, Air separator, Taco hvac