Transcription of CP2105 Data Sheet - Silicon Labs
{{id}} {{{paragraph}}}
Example: quiz answers
CP2105 Data Sheet - Silicon Labs
Rev. 11/13 Copyright 2013 by Silicon LaboratoriesCP2105CP2105 SINGLE-CHIP USB TO DUAL UART BRIDGES ingle-Chip USB to Dual UART Data Transfer Integrated USB transceiver; no external resistors required Integrated clock; no external crystal required Integrated 296-Byte One-Time Programmable ROM for storing customizable product information On-chip power-on reset circuit On-chip voltage regulator: V outputUSB Peripheral Function Controller USB Specification compliant; full-speed (12 Mbps) USB Suspend states supported via SUSPEND pinsTwo UART Interfaces ( Enhanced and Standard ) Flow control options:- Hardware (CTS / RTS)- Software (X-On / X-Off)- No flow control Configurable I/O ( V to VDD) using VIO pin Configurable I/O (VDD to 5 V) using external pull-up All modem interface signals available (when GPIO is not used)Enhanced UART Interface F
CP2105 Rev. 1.2 5 Table 3. UART and Suspend I/O DC Electrical Characteristics VDD=3.0 to 3.6V, VIO=1.8 V to VDD, –40 to +85°C unless otherwise specified. Parameters Test Condition Min Typ Max Unit Output High Voltage (VOH)IOH=–10µA IOH=–3mA …
Loading..
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: