Low-power dual operational amplifier - st.com

February 2016 DocID2471 Rev 17 1/24 This is information on a product in full production. www.st.com LM2904, LM2904A Low-power dual operational amplifier

  Operational, Amplifier, Operational amplifier

USB Power Delivery and Type-C - st.com

USB Type -C Overview USB Power Delivery specification introduces USB Type-C receptacle, plug and cable; they provide a smaller, thinner and more robust alternative to existing USB interconnect.

120-volt, 100-watt, DMOS audio amplifier with mute …

September 2010 Doc ID 6744 Rev 8 1/21 21 TDA7293 120-volt, 100-watt, DMOS audio amplifier with mute and standby Features Multipower BCD technology Very high operating voltage range (±50 V)

AN3128 Application note - st.com

June 2011 Doc ID 16918 Rev 5 1/105 AN3128 Application note STM32 embedded graphic objects/touchscreen library Introduction This library is a firmware package which contains a collection of routines, data structures,

AN4767 Application note - st.com

DocID028380 Rev 2 7/16 AN4767 Dual bank use cases 15 With dual bank, all the manipulation with the other bank is just another task of the main program.

  Applications

AN3155 Application note - st.com

October 2016 DocID17066 Rev 7 1/37 1 AN3155 Application note USART protocol used in the STM32 bootloader Introduction This application note describes the USART protocol used in the STM32 microcontroller

Datasheet - L78 - Positive voltage regulator ICs - …

TO- 2 2 0 TO-2 2 0 F P DPAK D² PAK Features • Output current up to 1.5 A • Output voltages of 5; 6; 8; 8.5; 9; 12; 15; 18; 24 V • Thermal overload protection

AN2867 Application note - st.com

May 2017 DocID15287 Rev 11 1/43 1 AN2867 Application note Oscillator design guide for STM8AF/AL/S and STM32 microcontrollers Introduction Many designers know oscillators based on Pierce-Gate topology (hereinafter referred to as

  Notes, Applications, Application note

AN4776 Application note - st.com

May 2017 DocID028459 Rev 2 1/73 1 AN4776 Application note General-purpose timer cookbook Introduction The timer peripheral is part of …

  Timer

Electronic transformer for a 12V halogen lamp - …

APPLICATION NOTE AN528/0999 1/4 ELECTRONIC TRANSFORMER FOR A 12V HALOGEN LAMP by P. Fichera, R. Scollo 1. INTRODUCTION Lighting that uses halogen lamps is commonly found

Instrumentation Amplifier with Precision Voltage Reference ...

Power Supply Rejection (dB) Frequency (Hz) 1 10 100 1k 10k 100k 1M G = 4 G = 10 G = 500 G = 100 NEGATIVE POWER SUPPLY REJECTION vs FREQUENCY 120 100 80 60 40 20 0 Power Supply Rejection (dB) Frequency (Hz) S

  Power, Supply, Rejection, Power supply rejection

Low Drop-Out (LDO) Linear Regulators: Design ...

• PSR: Power Supply Rejection (or ripple rejection) is a measure of the ac coupling between the input supply voltage on the output voltage. • Power Efficiency; This is the ratio of the output load power consumption to input supply power. Linear regulators are not really efficient especially at

  Power, Supply, Power supply, Rejection, Power supply rejection

NCS2006 - 3 MHz, 125 uA Low Power Operational Amplifier

SUPPLY CHARACTERISTICS Power Supply Rejection Ratio PSRR No Load 67 90 dB 64 Power Supply Quiescent Current IDD Per channel, no load 125 170 A 8. Performance guaranteed over the indicated operating temperature range by design and/or characterization.

  Power, Supply, Power supply, Rejection, Power supply rejection

AD827 High Speed, Low Power Dual Op Amp Data Sheet …

mode rejection ratio is a minimum of 80 dB. Power supply rejection ratio is maintained at better than 20 dB with input frequencies as high as 1 MHz, thus minimizing noise feedthrough from switching power supplies. The AD827 is also ideal for use in demanding video applica-tions, driving coaxial cables with less than 0.04% differential

  Power, Supply, Rejection, Power supply rejection

UC3842B - High Performance Current Mode Controllers

Power Supply Rejection Ratio (VCC = 12 V to 25 V, Note 5) PSRR − 70 − − 70 − dB Input Bias Current IIB − −2.0 −10 − −2.0 −10 A Propagation Delay (Current Sense Input to Output) tPLH(In/Out) − 150 300 − 150 300 ns OUTPUT SECTION Output Voltage Low State (ISink = 20 mA) (ISink = 200 mA) UC284XB, UC384XB UC384XBV, UC2843D

  Power, Supply, Rejection, Power supply rejection

Low-power dual operational amplifiers

Supply voltage rejection ratio V CC + = 5 V to 30 V, R s dB T min ≤ T amb ≤ T max 65 I CC Supply current, all amp, no load T min ≤ T amb ≤ T max V CC + = 5 V 0.7 1.2 mA T min ≤ T amb ≤ T max V CC + = 30 V 2 CMR Common mode rejection ratio R s dB T min ≤ T amb ≤ T max 60 I source Output current source V CC + = 15 V, V o = 2 V, V ...

  Power, Supply, Rejection

Turbidity measurement - WHO

• need power supply (mains or battery) • easily damaged ... than 5 NTU/JTU would be noticed by users and may cause rejection of the supply. • Where water is chlorinated, turbidity should be less than 5 NTU/JTU and preferably less than 1 NTU/JTU for chlorination to be effective.

  Power, Supply, Power supply, Rejection

Single-Supply, Rail-to-Rail, Low Power, FET Input Op Amp …

The AD820 is a precision, low power FET input op amp that can operate from a single supply of 5 V to 36 V, or dual supplies of ±2.5 V to ±18 V. It has true single-supply capability, with an input voltage range extending below the negative rail, allowing the AD820 to accommodate input signals below ground in the single-supply mode.

  Power, Supply