DC to 6 GHz Envelope and TruPwr RMS Detector Data Sheet ...
an internal 1.1 V reference voltage, which is available on the EREF pin. The ADL5511 can operate from dc to 6 GHz on signals with envelope bandwidths up to 130 MHz. The extracted envelope can be used for RF power amplifier (PA) linearization and efficiency enhancements and the rms output can be used for rms power measurement. The high rms
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
AD743 Ultralow Noise BiFET Op Amp Data Sheet …
www.analog.comREV. E Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its
Devices, Noise, Ad743 ultralow noise bifet op amp, Ad743, Ultralow, Bifet, Analog devices, Analog
MT-070: In-Amp Input RFI Protection - Analog …
www.analog.comRev.0, 10/08, WK Page 1 of 6 MT-070 TUTORIAL In-Amp Input RFI Protection . PROTECTING IN-AMPS AGAINST RFI . Real-world applications must deal with an ever increasing amount of radio frequency
LTC3108 - Ultralow Voltage Step-Up Converter and …
www.analog.comLTC3108 3108fc For more information www.linear.com/LTC3108 LDO
1.8 V Low Power CMOS Rail-to-Rail Input/Output …
www.analog.com1.8 V Low Power CMOS Rail-to-Rail Input/Output Operational Amplifier Data Sheet AD8515 Rev. E Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable.
Devices, Operational, Data, Input, Analog devices, Analog, Output, Cmos rail, Cmos, Rail, To rail, To rail input output operational amplifier data, Amplifier
Low Cost Micropower, Low Noise CMOS Rail-to …
www.analog.comLow Cost Micropower, Low Noise CMOS Rail-to-Rail, Input/Output Operational Amplifiers Data Sheet AD8613/AD8617/AD8619 Rev. H Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable.
Devices, Operational, Sheet, Data, Input, Analog devices, Analog, Output, Cmos rail, Cmos, Rail, To rail, Amplifier, Micropower, Input output operational amplifiers data sheet ad8613, Ad8613
Low Cost CMOS, High Speed, Rail-to-Rail Amplifiers
www.analog.comLow Cost CMOS, High Speed, Rail-to-Rail Amplifiers Data Sheet ADA4891-1/ADA4891-2/ADA4891-3/ADA4891-4 Rev. F Document Feedback Information furnished by Analog Devices ...
Zero-Drift, Single-Supply, Rail-to-Rail Input/Output ...
www.analog.comZero-Drift, Single-Supply, Rail-to-Rail Input/Output Operational Amplifier Data Sheet AD8628/AD8629/AD8630 FEATURES Lowest auto-zero amplifier noise Low offset voltage: 1 µV AD8628
Operational, Data, Input, Output, Rail, To rail input output operational amplifier data, Amplifier, To rail input
FEATURES DESCRIPTIO U - analog.com
www.analog.com1 LT1025 1025fb DESCRIPTIO U APPLICATIO S U 80µA Supply Current 4V to 36V Operation 0.5°C Initial Accuracy (A Version) Compatible with Standard Thermocouples (E, J, K, R, S, T) Auxiliary 10mV/°C Output Available in 8-Lead PDIP and SO Packages Thermocouple Cold Junction Compensator Centigrade Thermometer Temperature …
LT1173 - Micropower DC/DC Converter Adjustable …
www.analog.comLT1173 1 Micropower DC/DC Converter Adjustable and Fixed 5V, 12V VOUT 5V/DIV 0V PROGRAM 5V/DIV 5ms/DIV 1173 TA02 L1* 100µH LT1173 • TA01 + GND SW2 FB SW1 ILIM VIN 10 F LT1173
AD9850 CMOS, 125 MHz Complete DDS …
www.analog.comrev. h a cmos, 125 mhz complete dds synthesizer ad9850 functional block diagram clock out clock out analog in analog out dac rset …
Complete, Analog, 125 mhz complete dds, 125 mhz complete dds synthesizer, Synthesizer
Related documents
GasAlert Quattro // Operator's Manual
site.bw-gasmonitors.comthe detector and in the corresponding operator’s manual. Zeroing the Sensors To zero the sensors, refer to steps #1-3 in Calibration on page 9. Safety Information - Read First Use the detector only as specified in this operator’s manual and the technical reference guide, otherwise protection provided by the detector may be impaired.
Predicting the Phase Noise and Jitter ... - Designer’s Guide
designers-guide.org4 of 52 The Designer’s Guide Community www.designers-guide.org also rules out any PLL that is implemented wi th a phase detector that has a dead zone. A dead zone has the effect of opening the loop and letting the phase drift seemingly at ran-dom when the phase of the reference and the output of the voltage-controlled oscillator (VCO) are close.
Standard guide to fluorescence: instrument calibration and ...
nvlpubs.nist.govStandard Guide to Fluorescence -Instrument Calibration . and Validation . Paul C. DeRose . ... signals are typically observed, e.g., by a reference detector, and alignment is more difficult than for the emission wavelength accuracy determination. Fig. 1: Hg pen lamp spectrum .
Combo Smoke/CO Alarm User’s Guide - Kidde
www.kidde.comguide which should be saved for future reference and passed on to any subsequent owner. Teach children how to respond to the alarm and that they should never play with the unit. This Kidde Smoke/CO Alarm was designed to detect both smoke and carbon monoxide from any source of combustion in a residential environ-ment.
Guide, Reference, Smoke, Lamar, Kidde, Smoke co alarm, Kidde smoke co alarm
Smoke Alarm User’s Guide - Kidde
www.kidde.comguide which should be saved for future reference and passed on to any subsequent owner. Teach children how to respond to the alarm and that they should never play with the unit. Your Kidde Smoke Alarm was designed specifically for use in a residential environment. It is not designed for use in a recreational vehicle (RV) or boat.
Guide, Reference, Smoke, Lamar, Kidde, Smoke alarm, Kidde smoke alarm
1 MHz to 4 GHz, 80 dB Logarithmic Detector/Controller Data ...
www.analog.comLogarithmic Detector/Controller Data Sheet ADL5513 Rev. A Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed b y Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use.