Transcription of DediProg SF Software User Manual
{{id}} {{{paragraph}}}
DediProg SF Software user Manual Version DediProg user Manual 03/2019 DediProg Technology Co., Ltd 2019 All rights reserved. DediProg SF Software user Manual 1 Table of Content I. Introduction .. 2 II. Software Installation Guide .. 2 Operating System Requirement .. 2 USB Installation .. 2 III. DediProg SF Software Engineering 3 Environment Preparation .. 3 Identify the Target SPI Flash .. 4 Tool Bar Description .. 5 Edit Window Description .. 7 Configuration Window Description .. 9 Supported Devices, Software Version, Firmware Version .. 25 SPI NAND Programming Interface .. 26 IV. DediProg SF Software Production GUI.
Four software icons will appear on your desktop after installation. Icon “DediProg Engineering” is the engineering GUI, “DediProg Production” is the production GUI, “DpCmd” is the command line interface and “DediProg Help” is the user manual. 3.1 Environment Preparation 3.1.1 Connect the programmer to the PC through an USB cable.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}