Transcription of DEPARTMENT OF DEFENSE STANDARD PRACTICE FOR …
{{id}} {{{paragraph}}}
Example: tourism industry
DEPARTMENT OF DEFENSE STANDARD PRACTICE FOR …
MIL-STD-100G 9 JUNE 1997 SUPERSEDING MIL-STD-100F 9 SEPTEMBER 1996 DEPARTMENT OF DEFENSESTANDARD PRACTICEFORENGINEERING DRAWINGSAMSC N/AAREA DRPRDISTRIBUTION STATEMENT A. Approved for public release; distribution is MEASUREMENTSENSITIVEMIL-STD-100 GiiFOREWORD1. This Military STANDARD is approved for use by all Departments and Agencies of the Departmentof DEFENSE (DoD).2. Beneficial comments (recommendations, additions, deletions) and any pertinent data which maybe of use in improving this document should be addressed to: Commander, Army ArmamentResearch, Development and Engineering Center, ATTN: AMSTA-AR-EDE-S, Picatinny Arsenal,NJ 07806-5000, by using the Standardization Document Improvement Proposal (DD Form 1426)appearing at the end of this document or by The preferred STANDARD for Engineering Drawing practices is ASME Thecontractual application of MIL-STD-100 is permissible provided one or both of the followingconditions exist: it is required and fully justifiable that a DoD activity be the design activity the applicable end item requires Government logistics support4.
MIL-STD-100G iii agencies. The DRPRG addresses the entire range of issues from the current status and needed changes to MIL-STD-100, to electronic data storage and transmission, and the ongoing
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: