Transcription of Development Length, l for Tension Bars
{{id}} {{{paragraph}}}
Example: dental hygienist
Development Length, l for Tension Bars
Dr. Mohammed E. Haque, Page 1 of 5 Development length , ld for Tension Bars (ACI 318-08 Equation 12-1) ld = Development length (in) fy = Yield strength of the Tension rebars (psi) fc = Compressive strength of Concrete (psi); fc shall not exceed 100 psi db = bar diameter (in) According to ACI 318-08, Section 1. t is a rebar location factor that accounts for the position of rebars in freshly placed concrete. Where the horizontal rebars so placed that more than 12 inch of fresh concrete is cast in the member below he Development length or splice, use t = (ACI ). This condition contributes to the formation of entrapped air and moisture underneath of the rebars, resulting in partial loses of bond between concrete and rebars. For other reinforcement, use t = 12 Tension bar t = 12 Tension bar t = 3 40 cb+ Ktrdb ld = fy fc db t e s In which shall not be taken greater than cb + Ktr db Dr.
Dr. Mohammed E. Haque, P.E. Page 1 of 5 Development Length, l d for Tension Bars (ACI 318-08 Equation 12-1) l d = development length (in) f y = Yield strength of the tension rebars (psi)
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: