Transcription of Dimensioning and Tolerancing, Section 6, Drafting Manual
{{id}} {{{paragraph}}}
Example: dental hygienist
Dimensioning and Tolerancing, Section 6, Drafting Manual
GENIUM PUBLISHINGS ection 1 February 1997* Drafting MANUALD imensioning and TolerancingSymbolsUpdate 56* Supersedes issue of September Diameter - A diameter symbol is placed in front of anydimension value that is a diameter. See Figure 2. Diameter Counterbore Symbol - A counterbore symbol combinedwith a diameter symbol is placed in front of a specifiedcounterbore or spotface diameter. See Figure 3. Counterbore Countersink - The countersink symbol combined with adiameter symbol is placed in front of a specified countersinkdiameter. See Figure 4. Countersink GENERAL1 This Section is based on ASME Symbols uniqueto ANSI are also described for those who arecontractually obligated to comply with the older Symbols permit consistency in the way dimensions andtolerances are specified, and each symbol has a clearly definedmeaning.
Section 6.1 DRAFTING MANUAL Page 2 Dimensioning and Tolerancing August 1993* Symbols Update 47 2.4 Depth - A downward-pointing arrow is used for the depth symbol, and it is placed in front of the depth value in such applications as for counterbore and hole depths.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: