Transcription of DRIVEWAY STANDARDS AND SPECIFICATIONS
{{id}} {{{paragraph}}}
Example: tourism industry
DRIVEWAY STANDARDS AND SPECIFICATIONS
DRIVEWAY SPECIFICATIONS Updated February 2019 DRIVEWAY STANDARDS AND SPECIFICATIONS DRIVEWAY SPECIFICATIONS Updated February 2019 CONDITIONS GOVERNING DRIVEWAYS Driveways and foot paving construction may only be carried out by property owners, or accredited licensed contractors, subject to the following conditions. 1. No work is to start on Council property until a DRIVEWAY Application' is lodged and receipted by Council. Failure to do so will incur infringement notices and fines. 2. Council will not be held responsible for any Public Risk Claims or otherwise, arising from incorrectly installed or unapproved footpath crossings or associated works. 3. Workcover approved barriers, for the protection of the public, must be erected and maintained at any worksite on Council owned or managed property. 4. The contractor/owner is responsible for all damage caused to any public utility located in the footway/road area that is damaged as a result of work performed.
adjoining footpath with 12mm galvanised dowels (starting 350mm from each side then at 900mm centres). Laybacks shall be poured separately to the crossing. • Driveways are to be a minimum of 3 metres wide, maximum of 6 metres (unless otherwise s tated), for residential areas.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: