Transcription of EECS 100/43 Lab 2 – Function Generator and Oscilloscope
{{id}} {{{paragraph}}}
Summer 2007 Lab 2 EE100/EE43 University of California, Berkeley Department of EECS EECS 100/43 Lab 2 Function Generator and Oscilloscope 1. Objective In this lab you learn how to use the Oscilloscope and Function Generator 2. Equipment a. Breadboard b. Wire cutters c. Wires d. Oscilloscope e. Function Generator f. 1k resistor x 2 h. Various connectors (banana plugs-to-alligator clips) for connecting breadboard to power supply and for multimeter connections. 3. Theory a. The HP33120A Function Generator The front panel of your Function Generator is shown in Figure 1. This instrument outputs a time-varying periodic voltage signal (the OUTPUT connector, do not use the sync connector, refer to figure 2).
ii. The Systems and Controls of an Oscilloscope There are different types of oscilloscope on the market – analog, digital, digital storage etc. The oscilloscope that you have costs approximately $5000 and is a digital storage oscilloscope. Figure 11 is the front view of your scope. Figure 11. Your oscilloscope – the Agilent (or HP) 54645D
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}