Transcription of Electrofusion Installation Procedure Manual
{{id}} {{{paragraph}}}
Example: marketing
Electrofusion Installation Procedure Manual
Electrofusion Installation Procedure Manual It is important to read and understand all instructions before attempting a fusion. Permanent field installations should be done only by operators who have been properly trained and certified as qualified. Should you have any questions or need Installation training, please contact Central Plastics Company at 1-800-654-3872. or Your Local Central Plastics Representative. The following procedures were written to assist trained field personnel in the use of the Central Plastics Electrofusion system and Central Electrofusion Fittings. While technical data and advice contained herein is based upon tests and infor- mation believed to be reliable, user should not rely upon it absolutely for specific applications.
120V models — 30 Amp, 125 Volt, NEMA L5, twist-lock; INVERTERS ... Central Plastics Company recommends that a minimum of .007” to .010” of the pipe’s ... such as a repair application where a coupling will be pushed completely over one end of the pipe, it is recommended that pipe be scraped for the entire length of the cou- ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: