Transcription of ELECTRONIC ENGINE CONTROLLER - Chrysler
{{id}} {{{paragraph}}}
Example: quiz answers
ELECTRONIC ENGINE CONTROLLER - Chrysler
30 / electrical/electronics / 60 Way connectoreProMalternator Field control Driver(underneath heat sink)injector control Driver(underneath heat sink)ignition coil control8 Volt Distributor supply circuitryais Motor DriverMicroprocessorrFi suppressed circuit Boardthe MoPar aDVantageELECTRONIC ENGINE / electrical/electronics / 31 Crankshaft and camshaft sensors: Some aftermarket pickups have not worked properly with Mopar ENGINE controllers. Check for high circuit resistance associated with splices and fusible links; check for open and/or shorted wires. Closed throttle switch operation on AB, AD, AN bodies, 88 91 MY. TBI Dodge Trucks only. Damaged connector terminals: Remove orange gasket from bottom of SMEC/SBEC 60-way connector, reseat connector, and check for symptom/problem.
Open circuits and intermittent connections will not. • Vacuum system: Contaminants or leaks in vacuum lines, notably in line connected to MAP sensor can set MAP pneumatic Fault #13. • Fuel pressure and leak down. • Vehicle speed sensor operation. • Heater voltage for oxygen sensor.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: