Transcription of Energized Electrical Work Safety Procedures
{{id}} {{{paragraph}}}
Example: bachelor of science
Energized Electrical Work Safety Procedures
WRK Rev. 10/13/2010 ENVIRONMENT, Safety , RISK MANAGEMENT 1 Energized Electrical Work Safety Procedures Purpose The safest way to conduct Electrical work is to shut off electric power and work on de- Energized equipment. At CSUCI our intent and standard practice will be to avoid Energized Electrical work. In virtually all cases it should be possible to shut off power and utilize proper lock out Procedures , thus conducting work in the safest manner possible. However, there may arise extraordinary circumstances that necessitate work on Energized equipment, for example when shut down would create a significant Safety or health hazard or when work must be conducted near, but not on, live equipment. Diagnostic Procedures also often require Energized Electrical work. The following general approach will be used when conducting Energized Electrical work. Only authorized workers will be allowed to perform Electrical work. For a worker to be authorized training will be required.
This procedure applies to all electrical conductors and equipment operating at 50 volts nominal, or greater. This procedure also applies to live parts operating at less than 50 volts nominal, if there is an increased risk of exposure to electrical burns or to explosion due to electrical arcs.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: