Engineering & Design: Geometric Dimensioning SECTION 5

5-1 nadca Product Specifi cation Standards for Die Castings / 2006 Engineering & design : Geometric Dimensioning5 SECTION5 SECTION ContentsNADCA Introduction 5-22 What is GD&T?5-23 Why Should GD&T be Used?5-34 Datum Reference Frame5- , Secondary, Tertiary Features & Feature Vs. Datum Plane Vs. Datum Target Sizes & Locations5-65 Feature Control Frame5-66 Rule #1 Taylor Principle (Envelope Principle)5-77GD&T Symbols/Meanings5-88 Material Material Condition (MMC) Material Condition (LMC) of Feature Size (RFS)5-109 Location & Symmetry Tolerances5-1310 Profi le Tolerance5-1411 Run Out Tolerances5-1812 Orienta t ion Tolerances5 -1913 Form Tolerances5 S t ra igh t n e s s5 -2113. 2 Fl a t n e s s5 Circulatity (Roundness)5-2313.

5-2 NADCA Product Specifi cation Standards for Die Castings / 2006 Engineering & Design: Geometric Dimensioning 1 Introduction The concept of Geometric Dimensioning and Tolerancing (GD&T) was introduced by Stanley

Loading..

Tags:

  Design, Engineering, Dimensioning, Geometric, Geometric dimensioning, Nadca, Engineering amp design

Information