Transcription of Fabrication and W elding
{{id}} {{{paragraph}}}
Example: bankruptcy
Fabrication and W elding
Fabrication and Welding EngineeringThis page intentionally left blank Fabrication and Welding EngineeringRoger Timings AMSTERDAM BOSTON HEIDELBERG LONDON NEW YORK OXFORDPARIS SAN DIEGO SAN FRANCISCO SINGAPORE SYDNEY TOKYON ewnes is an imprint of Elsevier Newnes is an imprint of Elsevier Linacre House, Jordan Hill, Oxford OX2 8DP, UK 30 Corporate Drive, Suite 400, Burlington, MA 01803, USA Copyright 2008 Roger Timings, Published by Elsevier Ltd. All rights reserved The right of Roger Timings to be identifi ed as the author of this work has been asserted in accordance with the Copyright, Designs and Patents Act 1988 No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, mechanical, photocopying, recording or otherwise without the prior written permission of the publisher Permissions may be sought directly from Elsevier s Science & Technology Rights Department in Oxford, UK: phone ( 44) (0) 1865 843830; fax ( 44) (0) 1865 853333; email.
7.2 Roll-bending sheet metal and plate 296 7.3 Flow forming sheet metal 301 7.4 The principles of metal spinning 318 7.5 Swaging sheet metal 324 7.6 Basic fabrication procedures 330 Exercises 345 8 Structural steelwork and pipework 347 8.1 Rolled steel sections 348 8.2 Typical structural steel connections and assemblies 348
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: