Transcription of Fan and Shutter System Installation Guide
{{id}} {{{paragraph}}}
FORM: D8010. Fan and Shutter System Installation Guide NOTE: 2 & 3 speed fans are not setup to be hard wired. You will need to cut the power supply cord and connect directly to the black (hot), white (neutral), and green (ground) wires inside the cord if you want to hard wire them. - VARIABLE SPEED FANS ONLY - Wiring information for each variable speed fan is located on a sticker on the motor. If you will be hard wiring one of our variable speed fans, make note of the black, white, and green wire connections before disconnecting the power supply cord, and make sure the wire used to hard wire the fan is connected to the same terminals. Our watertight wiring connectors or flexible conduit connectors can be screwed directly to any of the variable speed fan motors.
Mounting Shutter Motor to Shutter Attaching Motor Arm Linkage to Shutter Tie Bar
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}