Transcription of Fiber Optics Troubleshooting - National Tree
{{id}} {{{paragraph}}}
CAUTION!THE BULB WITHIN THE ELEC-TRICAL HOUSING GENERATES HIGH ALLOW THE UNIT TO COOL Optic products contain three main parts that canbe replaced: the bulb and motor, located inside thebase, and the AC adapter cord. Follow the instructionsbelow to determine which part may need the AC adapter from power source. Remove uppertree/bush portion of product from pot the bottom of the pot base that contains the motorassembly from the upper section of the pot base. Dependingon the model, motor assembly can accessed by squeezinglatch tabs, or by removing the screws using a Optics TroubleshootingNATIONAL TREE COMPANY2 Commerce Drive, Cranford, NJ 07016 USA REPLACEMENTIMPORTANT:Replace bulb with one of the same sizeand voltage as originally installed in the product. Bulb sizeand voltage is printed on or near the bulb.
Fiber Optic products contain three main parts that can be replaced: the bulb and motor, located inside the base, and the AC adapter cord. Follow the instructions below to determine which part may need replacing. Unplug the AC adapter from power source. Remove upper tree/bush portion of product from pot base.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}