Transcription of Finishing Drywall 5 Systems - USG
{{id}} {{{paragraph}}}
Example: quiz answers
Finishing Drywall 5 Systems - USG
1555 Finishing Drywall SystemsLevels of Gypsum FinishingThe finished appearance of a Drywall wall or ceiling is largely depen-dent upon the quality of the framing job and the care exercised inapplying the Drywall panels. The better the framing and cladding, theeasier it is to have a near-perfect wall. Once that is accomplished, thelast remaining challenge is to finish the joints to meet your appearanceexpectations. This chapter helps you determine the level of quality youneed in your finish and shows you how to obtain that various organizations provide information about recommendedstandards or tolerances for Finishing of Drywall joints. See pages 435 and442 in the Appendix for information about standards and instructions on the safe use of joint compounds, texturing materialsand related products, see Chapter 13, Safety Considerations, documents traditionally have used nonspecific terms such as industry standards or workmanlike finish to describe how finishedgypsum board walls and ceilings should look.
other areas with pedestrian traffic. Tape and fastener heads need not be covered with joint compound. Surface shall be free of excess joint compound. Tool marks and ridges are acceptable. Level 2May be used with setting-type compound for areas where water-resistant gypsum backing board, specification ASTM C630, is used as a substrate for tile.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: