Building work that does not require a building consent

GUIDANCE Building Act 2004 THIRD EDITION 2014 - AMENDED AUGUST 2017 Building work that does not require a building consent

  Guidance

C/AS2 - Acceptable Solution for Acceptable Solution for ...

C/AS2 Acceptable Solution for Buildings with Sleeping (non institutional) (Risk Group SM) For New Zealand Building Code Clauses C1-C6 Protection from Fire

Earthquake geotechnical engineering practice

Earthquake geotechnical engineering is a highly specialised field. As such the investigations for this need to be developed and carried out by an appropriately qualified and experienced geotechnical engineer or engineering geologist (referred to herein as the geotechnical professional). For the purposes of this document ‘geotechnical

  Geotechnical

E2 External Moisture

For single- and two-storey concrete and concrete masonry construction within specific limitations: E2/AS3. For light steel framed buildings up to 3 storeys, within specific limitations: E2/AS4. E2.3.3 Ground contact or proximity All walls, floors and structural elements in ground contact or proximity, except for buildings where external

  Light, Concrete

Module 6: Earthquake resistant retaining wall design

guidance on earthquake design aspects for retaining . structures that are not well covered in these handbooks or elsewhere. The main objective is to identify situations where seismic design of retaining structures should be considered, to provide the necessary seismic parameters, and to identify key issues relating to seismic design.

  Design, Seismic, Structure, Walls, Module, Resistant, Seismic design, Retaining, Earthquake, Module 6, Retaining structures, Earthquake resistant retaining wall design

Worked Example 4 | Design of a tied-back retaining wall to ...

Design of a tied-back retaining wall to resist earthquake loading . Worked example to accompany MBIE Guidance on the seismic design of retaining structures for residential sites in Greater Christchurch (Version 2) November 2014 . Tied-back retaining walls were used originally as a substitute for braced retaining walls in deep excavations.

  Design, Seismic, Structure, Walls, Loading, Seismic design, Retaining, Earthquake, Sisters, Retaining structures, Retaining wall to resist earthquake loading

Acceptable Solutions and Verification Methods

4.2 Sizing of downpipes 42 4.3 Installation of downpipes 42 5.0 Roof Gutters 42 5.1 Size of roof gutter 42 5.2 Materials44 5.3 Gradients44 5.4 Thermal movement 44 5.5 Overflow outlets 44 Appendix A Rainfall intensities 45 Index 47 Contents Amend 4 Dec 2000 Amend 4 …

  Verification, Solutions, Methods, Acceptable, Roof, Appendix, Sizing, Acceptable solutions and verification methods

Acceptable Solutions and Verification Methods

4.2 Sizing of downpipes 42 4.3 Installation of downpipes 42 5.0 Roof Gutters 42 5.1 Size of roof gutter 42 5.2 Materials44 5.3 Gradients44 5.4 Thermal movement 44 5.5 Overflow outlets 44 E1/AS1 Appendix A Rainfall intensities 45 Acceptable Solution E1/AS2 52 1.0 AS/NZS 3500.3 Stormwater Dec 2000 drainage52 Index 56 Contents Amend 4

  Verification, Solutions, Methods, Acceptable, Roof, Appendix, Sizing, Acceptable solutions and verification methods

Commentary for Acceptable Solutions C/AS1 to C/AS7 ...

December 2013. Contents Acceptable Solutions C/AS1 to C/AS7 Part 1: General 2 ... 4.11 Protected shafts 31 4.13 Floors 32 4.14 Subfloor spaces 32 ... INNOVATION AND EMPLOYMENT – 15 FEBRUARY 2013 I 1 Part 5: Control of external fire spread 34 5.1 General principles 34 5.2 Horizontal fire spread from external walls 36 5.5 Table method for ...

  2013, December, December 2013

Constructing Cavities - Building Performance

Table 23 (’Properties of roof underlays and building wraps‘). Install the wall underlay directly over the framing. Install the cavity battens directly over the wall underlay as described in Cavity battens on page 9. No additional wall underlay is needed between the wall cladding and the cavity battens except in the following situations.

  Building, Constructing, Wrap, Cavities, Building wraps, Constructing cavities

Accredited Employers Programme

Health and Safety at Work Act 2015 (HSWA). The audit standards are aligned to AS/NZS 4801:2001, the joint Australia/New Zealand Standard for Occupational Health and Safety Management Systems. What do the audit standards do? Use of the AEP audit standards enables ACC to determine, under the Framework for Accredited

  Safety, Zealand, New zealand

Safe Stacking and Storage - University of Auckland

safety legislation. There is an enormous variety of storage systems and stacking methods in use today. Materials handling equipment, too, is extremely diverse, ranging from hand trolleys through various types of forklift truck to sophisticated warehouse robots. Obviously, this booklet cannot deal with all these in detail. However, it does set ...

  Safety

Barge Stability Guidelines - Maritime New Zealand

Proper planning is common sense – safety is no accident. 10 BASIC STABILITY RULES FOR SAFE PONTOON BARGE OPERATIONS Consult a Maritime NZ recognised Ship Surveyor, or Naval Architect in any cases of doubt. Know the lightship displacement of the barge before loading. Know the lightship centre of gravity (KG) for the barge.

  Guidelines, Safety, Stability, Zealand, Barge, New zealand, Barge stability guidelines

Compliance Document for New Zealand Building Code …

Standards new Zealand NZS 4121: 2001 Design for access and mobility – Buildings and AS1 4.2.7 associated facilities Standards Australia AS 1976: 1992 Vitreous china used in sanitary appliances AS1 2.6.1 AS 3588: 1996 Shower bases and shower modules AS1 2.6.1 Standards Australia/new Zealand AS/NZS 1730: 1996 Washbasins AS1 2.6.1

  Zealand, New zealand

NEW ZEALAND DATA SHEET EFUDIX® - Medsafe

NEW ZEALAND DATA SHEET EFUDIX® 4 Drugs which have caused, are suspected to have caused, or may be expected to cause, an increased incidence of human fetal malformations or irreversible damage. These drugs may also have adverse pharmacological effects. Accompanying texts should be consulted for further details.

  Zealand, New zealand

The cost of running a vehicle - NZ Transport Agency

NZ TRANSPORT AGENCY THE COST OF RUNNING A VEHICLE // 2 COMMON OPERATING COSTS TO CONSIDER AVERAGE COSTS Tyres The cost of tyres varies and depends on the size and quality of tyre. A set of tyres will usually last 30,000 to 40,000km. Vehicle service, repairs and maintenance Your vehicle should be serviced at regular intervals – usually