Transcription of Flare Identification Chart
{{id}} {{{paragraph}}}
Example: bankruptcy
Flare Identification Chart
Tube + or - .0073/16 .272 1/4 .352 5/16 .418 3/8 .493 1/2 .632 Tube + or - .0103/16 .270 1/4 .350 5/16 .415 + or - .0153/8 .475 1/2 .645 Double/SAE 45 Degree FlareDIN/ISO Bubble FlareAN/JIC 37 Degree Single Flare90 DEG+ or - 445 DEGTool MarksAcceptable Less ThanTube RequiredNo Nicks AllowedDebur Die Blocks If NeededRadius RequiredNo Nicks AllowedDebur Die Blocks If MarksAcceptable Flare Less ThanTube + or - . RequiredNo Nicks AllowedDebur Die Blocks If NeededFlare Less ThanTube MarksAcceptable 115 DEG+ or - that the Flare is the correct profile for the components involvedAutomotive fittings are always a 45 deg.
Flare O.D. + or - .007 ... 10mm x 1.0 thread fitting but will hopefully strip the threads when you tighten it down You can start the 10mm x 1.0 thread nut in a 3/8 x 24 UNF thread fitting but it will immediatly begin stripping the threads 74 DEG
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: