Transcription of Fluorex Paintfilms - Soliant Introduction
{{id}} {{{paragraph}}}
Example: quiz answers
Fluorex Paintfilms - Soliant Introduction
Fluorex Paintfilm Laminates Processing Guide Note: The information contained within this document is considered recommended guidelines only, and intended to familiarize our customers with Fluorex products. Processing parameters for any thermoformed or injection molded part is dependent on the design configuration and materials used in the process. In order to determine the best possible processing conditions, each part will require testing prior to implementation into any production environment For more information, please visit our website: Or contact your local AkzoNobel Specialty Finishes office. Fluorex Paintfilms GTS-9/13 2 Table of contents Materials: Page 1) Description 3 2) Typical properties 3 3) Handling and Storage 4 Thermoforming process: 1) Equipment 5 2) Thermoform Mold 6 3) Trimming 7 4) Appliqu (insert) handling recommendations 7 5) Thermoform process conditions 8 6) Trouble shooting (thermoforming) 8+ Injection mol
GTS-9/13 6 Note: drying is only necessary when the backing sheet contains too much moisture 2) Thermoforming Mold: Fluorex® film laminate is normally formed over a male tool with the decorated side (read ‘paint’)
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: