Transcription of Fly Tying Bench plans - Hooked On Flies
{{id}} {{{paragraph}}}
Example: barber
Fly Tying Bench plans - Hooked On Flies
Fly Tying Bench plans Materials List: *Qty 1 - Oak 24 x 11 x thick *Qty 2 Oak 24 x 3 x thick *Qty 4 Oak 24 x 2 x thick *Qty 1 Oak 24 x 1 x thick Qty 21 1 drywall (or other) screws Qty 7 Oak wood plugs Qty 1 3' x dowel rod Wood glue Polyurethane 80 and 150 grit sandpaper Fine steel wool Tools needed: Pipe clamps (optional) Hole punch Miter saw (substitute hand saw) Pencil Tape measure Drill Rubber mallet/hammer 7/64 , 1/8 , 1/4" and 3/8 drill bit(s). Paint brush Router Hack saw/coping saw *Note These plans are designed with simplicity in mind.
4) Next, using the measurements in step 3, mark and pre-drill the holes (7/64” drill bit) on the underside of the rear shelf support and the supports for the two side arms
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
The Research Basis for the Hooked, Hooked, Chapter 11 Hooked on Learning: the Roots of, Chapter 11: Hooked on Learning, Chapter 11 Hooked on Learning: the Roots of Motivation, How the food giants hooked us, Hooking Up, Hanging Out, and Hoping for, PROCEDURE FOR SEA TURTLE FISHING HOOK, PROCEDURE FOR SEA TURTLE FISHING HOOK REMOVAL, Hooked on a feeling, Hooked on Linguistics, October 2014, SPLICES, DEVELOPMENT AND STANDARD HOOKS, SPLICES, DEVELOPMENT AND STANDARD HOOKS FOR, SPLICES, DEVELOPMENT & STANDARD HOOKS