PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: barber

FOOTCANDLE LIGHT GUIDE - Lighting Design Lab

FO OT C ANDLE LIGHT GuideFOOTCANDLE LIGHT GUIDEF ootcandles are the most common unit of measure used by Lighting professionals to calculate LIGHT levels in businesses and outdoor spaces. A FOOTCANDLE is de ned as the illuminance on a one square foot surface from a uniform source of LIGHT . The Illuminating engineering Society (IES) recommends the following FOOTCANDLE levels to ensure adequate illumination and safety for occupants. Below is a guideline for common areas to assist in achieving appropriate LIGHT levels with the greatest energy-e Area & Task A ver age Maintained Footcandles (Horizontal) (FC)Range of Maintained Footcandles (Horizontal) (FC)Aver age Maintained Footcandles (V er tical) (FC)Range of Maintained Footcandles (V er tical) (FC)CommentsWAREHOUSING & STORAGEB ulky Items Large Labels105 Small Items Small Labels3015 Cold Storage2010 - 30105 - 15 Open War ehouse2010 - 30 War ehouse w/Aisles2010 - 30105 - 15 COMMERCIAL OFFICEOpen Office4030 - 50@30 Above Finished Floor (AFF)Privat e Office4030 - 50@30 AFFC onfer ence Room30 Matte surface reflectance for the table 40% - 30 Lunch & Break Room155 - 20 EDUCATIONAL (SCHOOLS)Classr oom4030 - 50@30 AFFG ymnasiumClass I (Pro or Div.)

Engineering Society (IES) recommends the following footcandle levels to ensure adequate illumination and safety for occupants. Below is a guideline for common areas to assist in achieving appropriate light levels with the greatest energy-e˚ciency .

Fullscreen Download
Loading..

Tags:

  Engineering

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Transcription of FOOTCANDLE LIGHT GUIDE - Lighting Design Lab

Documents from same domain

THE BASICS of LEDs - Lighting Design Lab

www.lightingdesignlab.com

THE BASICS of LEDs DEVELOPED BY: Eric Strandberg, LC & Jeff Robbins, LC, MIES PRESENTED BY: Jeff Robbins Fall, 2012 . 2 LIGHTING DESIGN LAB A Northwest utility funded lighting education facility promoting commercial and industrial energy conservation. 3

  Basics

Related documents

DDOT Speed Hump Page Engineering Guidelines

ddot.dc.gov

conduct an engineering evaluation prior to installation of speed humps to determine if installation at the candidate location is in conformance with the criteria and guidelines in this document. In its evaluation, DDOT will consider the potential impacts of speed humps on the operations of the surrounding transportation network.

  Guidelines, Engineering, Speed, Engineering guidelines

CORROSION GUIDELINES

dot.ca.gov

Samples meeting the requirements of Section 6.1 of these guidelines are sent to the Materials Engineering and Testing Services (METS), Corrosion Branch for chloride and sulfate testing. Documentation of the corrosion investigation, sampling, corrosion testing, done by the districts are the responsibility of the District Materials Branch.

  Guidelines, Engineering

BRIDGE CONSTRUCTION MANUAL GUIDELINES TO …

www2.gov.bc.ca

Bridge Construction Manual Guidelines to Project Supervisors Bridge Engineering Page 2 Revision: April 1996 PREFACE This Manual has been prepared to assist the Project Supervisor in the supervision of bridge construction projects. Its intent is to establish a basis for the relationship with the Contractor and

  Guidelines, Manual, Bridge, Project, Engineering, Construction, Supervisor, Bridge construction manual guidelines to, Bridge construction manual guidelines to project supervisors

GUIDELINES FOR EMBANKMENT CONSTRUCTION

www.dot.ny.gov

geotechnical engineering manual: guidelines for embankment construction gem-12 revision #4 state of new york department of transportation geotechnical engineering bureau august 2015 . eb 15-025 page 2 of 30 table of contents 1.

  Guidelines, Engineering, Construction, Embankment, Guidelines for embankment construction

ABSTRACT GUIDELINES - AISES

www.aises.org

ABSTRACT GUIDELINES: Abstracts must include sufficient information for reviewers to judge the nature and significance of the topic, the adequacy of the investigative strategy, the nature of the results, and the conclusions. The abstract should summarize the substantive results of the work and not merely list topics to be discussed.

  Guidelines

U.S. POSTAL SERVICE STANDARD WALL-MOUNTED …

about.usps.com

Sep 03, 2004 · USPS ENGINEERING, DELIVERY AND RETAIL SYSTEMS 8403 LEE HIGHWAY MERRIFIELD VA 22082-8101 1.3.1 Interested Manufacturers – Manufacturers interested in selling wall-mounted, centralized mail receptacles to the public are required to obtain Postal ServiceTM approval. See section 6 for the application process.

  Engineering, Usps, Usps engineering

XFLR5 Analysis of foils and wings operating at low ...

engineering.purdue.edu

Guidelines for QFLR5 v0.03 4/58 October 2009 1 Purpose This document is not intended as a formal help manual, but rather as an aid in using XFLR5. Its purpose is to explain the methods used in the calculations, and to provide assistance for the less intuitive aspects of the software. 2 Introduction 2.1 Code limitations and domain of validity

  Guidelines

Related search queries

Speed, Engineering Guidelines, Engineering, Guidelines, BRIDGE CONSTRUCTION MANUAL GUIDELINES TO, Bridge Construction Manual Guidelines to Project Supervisors, Guidelines for embankment construction, USPS ENGINEERING