Transcription of FRP Specifications - Strongwell
{{id}} {{{paragraph}}}
FRP Specifications Section 06 71 00 Fiberglass Reinforced Polymer (FRP) Structural Shapes/Plate and Fabrications REVISED BRISTOL FACILITY 400 Commonwealth Ave., Bristol, VA 24201 USA (276) 645-8000 HIGHLANDS FACILITY CHATFIELD FACILITY 26770 Newbanks Road, Abingdon, VA 24210 USA (276) 645-8000 1610 Highway 52 South, Chatfield, MN 55923 USA (507) 867-3479 March 2020 067100-1 Liability Disclaimer The Specifications and material property information contained in these Strongwell Specifications are provided as a service to architects and Design Engineers who desire to use this information in the creation of construction specification documents. The use of these Specifications is at your own risk. These Specifications may contain errors, omissions, and inaccuracies. NEITHER Strongwell NOR ANY OTHER PARTY INVOLVED IN THE CREATION OF THESE Specifications SHALL BE LIABLE FOR ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES ARISING OUT OF OR CONNECTED IN ANY MANNER WITH YOUR ACCESS TO OR USE OF THESE Strongwell Specifications INCLUDING, WITHOUT LIMITATION, ANY LOST PROFITS, BUSINESS INTERRUPTION, OR LOSS OF PROGRAMS OR INFORMATION, EVEN IF Strongwell HAS BEEN SPECIFICALLY ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
All structural shapes shall contain a UV inhibitor. E. If specified, after fabrication, all cut ends, holes, and abrasions of FRP shapes shall be sealed with a compatible resin coating. F. FRP products exposed to weather shall contain an ultraviolet inhibitor. Should
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}