Transcription of Fuel Sender Installation - Tanks Inc
{{id}} {{{paragraph}}}
Example: tourism industry
Fuel Sender Installation - Tanks Inc
fuel Sender Installation 1) For tank depths of 6 to 15-1/2 , it will be necessary to remove the lower mounting bracket. a. Begin by removing the two screws and nuts from the lower mounting bracket. These will be discarded. b. Remove the two screws from the plastic rheostat housing. Save these screws to use later. c. Remove the plastic rheostat housing from the lower mounting bracket and then discard this portion of the mounting bracket. d. Reinstall the plastic rheostat housing to the upper mounting bracket and secure using the screws you removed in step b . (for tank depths 6-7 inches, the top screw is not needed) 2) Adjust the float length and pivot point for the tank s depth. See diagram below. FLOATSIDE12 Tank Depth+ 18"18"Cut Off Excess Float ArmSlide Float Arm Until Topof Float is Approximately18" Below the Bottom of theMounting PlateMove the Pivot Point to the Centerof the Tank.
Fuel Sender Installation 1) For tank depths of 6” to 15-1/2”, it will be necessary to remove the lower mounting bracket. a. Begin by removing the two screws and nuts from the lower mounting bracket.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Arm Fuel Level Sender Siemens VDO, LEVEL SENDER, LEVEL SENDER - 3 TERMINAL, VDO Marine Instruments, LEVEL, P0462 Fuel Level Sensor Circuit Low Voltage, Sample letter of recommendation, Sample’letter’of’recommendation, Sender, AUTOMATING THE MAIL FORARDING PROCESSW, Gauge Installation Instructions, EXPRESSSCRIPTS, EXPRESS SCRIPTS